Differences

This shows you the differences between two versions of the page.

--- external:examples:reaper_timecode_on_same_pc [2020/02/13 14:01] – created icke_siegen
+++ external:examples:reaper_timecode_on_same_pc [2020/04/29 04:59] (current) – [Prerequisites] icke_siegen
@@ Line 7: / Line 7: @@
 ===== Prerequisites =====
-  - Titan PC-Suite, from v12 on (AvoKey required)
+  - Titan PC-Suite, from v12 on (External AvoKey or T2 required - T1 or Editor Avokey does not work)
   - loopMIDI (see [[external:software_list|]], to route the MIDI signal from one program to another
   - Reaper (see [[external:software_list|]])
@@ Line 85: / Line 85: @@
 This also works together with Reaper being controlled by Titan via MMC, like described in [[external:examples:reaper_mmc_on_same_pc|]]
+{{:external:examples:reaper_timecode_running.png|}}
+You can now use this as timecode source to sync cuelists to music coming from Reaper.
+I noticed a gap between the timestamps in Reaper and in Titan. This seems to be due to both, Reaper, as well as Titan/USB Expert, and needs to be investigated further.
+==== - How to debug ====
+If things do not work as expected then there are some tools which help finding the fault:
+=== - loopMIDI ===
+loopMIDI shows the number of transmitted data. This number increases with every command, note or message. With timecode, this number increases continuously and rather fast.
+{{:external:examples:debug_loopmidi.png|}}
+=== - USB Expert Console ===
+Open the USB Expert Console. This must show loopMIDI Port 1 as connected panel (top-left). Select the ''MIDI'' tab top-right, click ''Watch MIDI'', in the MIDI watcher window select MIDI Input and Raw MIDI. Now, as you send a command, it is shown in the MIDI watcher, with continuously incoming data like this:
+{{:external:examples:debug_timecode_usbexpert.png?500|}}
+Additionally, on the Timecode tab (top-right), you should see the real timecode values running:
+{{:external:examples:debug_timecode_usbexpert_2.png?500|}}
+=== - MIDI-OX ===
+Install and launch MIDI-OX (see [[external:software_list|]]. From the Options menu select ''MIDI Devices''. Make sure loopMIDI Port is listed as MIDI Input but isn't mapped to any output (yes, you can create a feedback loop, and yes, you do not want to do this...)
+{{:external:examples:debug_midiox_1.png|}}
+From the View menu select ''Input Monitor...''. In this window, all incoming MIDI data are shown. You will see the cpntinuous stream of MTC Quarter Freame messages:
+{{:external:examples:debug_timecode_midiox.png|}}