macros:property:patch.repatch.bunchup
Differences
This shows you the differences between two versions of the page.
| macros:property:patch.repatch.bunchup [2025/04/29 09:49] – created icke_siegen | macros:property:patch.repatch.bunchup [2025/04/29 17:01] (current) – icke_siegen | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ^ type | [[: | ^ type | [[: | ||
| ^ values | Retain layout, Bunch up, Bunch up with offset | | ^ values | Retain layout, Bunch up, Bunch up with offset | | ||
| + | |||
| + | During discussing [[macros: | ||
| + | |||
| + | > The **RepatchSelectedFixtures** function processes fixtures in the selection order, if you use groups to select the fixtures this should be something to be aware of. Partially because of this I also set the **Patch.Repatch.BunchUp** property to **BunchUp** since with the group I was trying (201: All MegaPointe in a copy of the demo show) it failed as it was attempting to repatch to a negative DMX address. I assume this was because higher DMX addresses appeared in the selection before lower ones however I didn’t look into it in detail. In principle **RetainLayout** would be fine to use but you do need to ensure that the specified DMX address and selection order are valid for what you are trying to do. | ||
| == example == | == example == | ||
macros/property/patch.repatch.bunchup.1745920159.txt.gz · Last modified: 2025/04/29 09:49 by icke_siegen